The presence of alkalinity in a water sample may be due to many different substances. However, for the sake of simplicity, the presence of bicarbonate, carbonate, and hydroxide ions is commonly considered as alkalinity. The points of change in colour of phenolphthalein and methyl orange indicators, which occur at pH 8.3 and pH 4.3 provide standard reference points which are almost universally used to express alkalinity.
Very high alkalinity values can be undesirable in an industrial water supply. For example, the presence of a high methyl orange alkalinity should be avoided in boiler feed water because of the resultant carbon dioxide content of the steam. Carbon dioxide usually is responsible for the corrosion of steam and return lines. High boiler water alkalinities are also undesirable because the presence of high hydroxide ion concentration is the primary cause of caustic metal embrittlement. A very high boiler alkalinity can also lead to an undesirable carryover condition. On the other hand, the alkalinity of boiler water must be sufficiently high to protect the boiler metal against acidic corrosion and to ensure precipitation of scale forming salts. Usual treatment approaches include setting both a minimum alkalinity level and an operating range.
Hydroxide alkalinity may be determined by adding barium chloride prior to titration to precipitate the carbonate ion from solution, allowing direct titration of the hydroxide alkalinity. Measurement of hydroxide alkalinity is also used to control lime soda softeners.
In cooling water systems, alkalinity is of major importance since the total alkalinity of a water is one factor that must be considered when predicting the tendency for the water to precipitate calcium carbonate scale. Depending on the choice of chemical treatments to protect against corrosion and scale formation, the operating alkalinity and pH ranges are chosen to balance these two features.
Water Testing Procedures Manual ( Full Range ) ::: Available with us at 2700 INR or 54 US$ or 207 AED
Avoid contact with EYE / Hand and other CHEMICALS and Gases.
For determination of Hydroxide alkalinity only, barium chloride is added prior to titration to precipitate the carbonate ions. Titration is then taken only to the phenolphthalein end point. A pH meter may be used instead of the indicators to determine the end points of the titration.
NUMBER OF DROPS OF TK9 p-Alkalinity as CaCO3
1>>>>>>>>>>>>>>>>>>>>>>>>>>25
2>>>>>>>>>>>>>>>>>>>>>>>>>>50
3>>>>>>>>>>>>>>>>>>>>>>>>>>75
4>>>>>>>>>>>>>>>>>>>>>>>>>>100
5>>>>>>>>>>>>>>>>>>>>>>>>>>125
10>>>>>>>>>>>>>>>>>>>>>>>>>>250
20>>>>>>>>>>>>>>>>>>>>>>>>>>500
30>>>>>>>>>>>>>>>>>>>>>>>>>>750
40>>>>>>>>>>>>>>>>>>>>>>>>>>1000
Optimum Result : p-Alkalinity level is between 100 to 150 PPM is suggested.
if p-Alkalinity level is more then 150 ppm then level should be reduced by increased BLOW DOWN process with immediate effect.
For Below 50 ppm , Dose ½ Ltrs of RXSOL-50-5001-BWT for 1000 Ltrs of BOILER WATER , to maintain p-Alkalinity level 100 ppm.
Refill pack : REPLACEMENTS
TK7 : ECONOMIC PACK ( 100 / 200 / 500 ml ) available
TK8 : ECONOMIC PACK ( 100 / 200 / 500 ml ) available
TK9 : ECONOMIC PACK ( 100 / 200 / 500 ml ) available
total alkalinity test kit manufacturer, Exporter and supplier in mumbai, kandla, Gandhidham, chennai, Ennore, Kolkata, Kakinada, Vizag, Manglore, Goa, Tuticorin, Fujairah, Dubai, Sharjah, Uae, Middle East